On Correct Configuration of GPRS in Different Work Modes of Baima IP Modem and the Server

1. Connection diagram

2. Open DTU configuration software and connect server

DTU configuration software page

Server (using network debug assistant as a tool)

3. Configuration of GPRS in Different Work Modes of DTU (IP Modem)and the Server

GPRS work modes: include FTCP, HTCP, CTCP, NUDP, CUDP and HUDP(as below). Among them: FTCP, HTCP, CTCP are DTU TCP clients, only registration package and heartbeat package are not the same; NUDP, CUDP, HUDP are DTU do UDP client, but registration package and heartbeat package is different.

Taking Baima BMD100GPRS IP Modemas an example, this paper expounds the ways and differences of establishing connection between BMD100 and the server under TCP and UDP modes.

3.1, A connection between the server and BMD100 - TCP mode

First, open the server and select TCP Server for protocol type

The second step goes into BMD100 configuration page and sets GPRS work mode to TCP (where FTCP is selected), and the center address (example: sundge.vip) and port number (example: 10000) correspond to the server, and then save the parameters and restart the device.

After successful connection, you can observe that the server received heartbeat packets and data sent by BMD100:

3.2, A connection between the server and BMD100 - UDP mode

First, open the server and select UDP Server for protocol type

The second step goes into BMD100 configuration page and sets GPRS work mode to UDP (where CUDP is selected), and the center address (example: sundge.vip) and port number (example: 10000) correspond to the server respectively. Unlike the TCP setting, the custom registration package and the custom heartbeat package need to be configured, and then save the parameters and restart the equipment.

After successful connection, you can observe that the server received the heartbeat packets and data sent by BMD100: